M3VE 3-way active main monitor
For Mastering, Tracking and Mixing. Bi-amped / passive crossover between mid and high.
The Dynaudio Professional M3VE monitor system that takes monitoring to a whole new level with a significant upgrade from its predecessor - the renowned M3A 3-way monitor. Two speakers are powered by a single four channel Lab.gruppen PLM 12k44 amplifier, using the integrated Lake active cross-over between LF and MF, while passively filtering the MF/HF cross-over point.
With Dynaudio ESOTAR² driver technology, M3VE takes over where most other monitor systems give up. Attention to detail, underpinned by a 22Hz - 21kHz frequency response and beyond 133dB SPL, M3VE leaves no room for desire in terms of resolution, range or power.
Three-Way Main Monitor
For in-wall or free standing setups
Passive MF/HF crossover
Matched with Lab.gruppen PLM 12k44 amplifier
Made in Denmark
System: 3-way Active Main Monitor
Frequency Response (±3dB): 22Hz - 21kHz
Peak SPL 1m, pair (IEC Short Term): > 133dB peak
Amplifier minimum: 2 x Lab.gruppen PLM10000Q
Resonance Frequency: 24Hz
Internal Cabinet Volume: 145 liters
Bass Principle: Bass reflex
Amplifier: 1/2 Lab-gruppen PLM10000Q (2 channels pr speaker). Preset: M3VE V05
Tweeter: Esotar² 28mm soft dome Magnetic fluid, Metal rear chamber, Pure alu wire voice coil, 4 mm die-cast alu front, Neodym magnet material
Midranges: 15cm with 75mm diameter pure aluminum wire voice coil, one-piece molded MSP cone
Woofer: Esotar 30cm with 75mm diameter pure copper wire voice-coil, MSP-cone, long stroke
Dimensions (WxHxL): 555 x 775 x 505mm
Cabinet: 25mm MDF, strategically braced and damped. Low turbulence reflex-ports. Separate chambers for each woofer.
Crossover: Woofers/hightone: active dsp-based, in-amp Lake processor. Midrange/tweeter: passive wir air-coils only, low dielectrium capacitors and zero-compression resistors.